Designing with Canbrace® X Panel
Canbrace® X Panels are fitted at pre-nail plants or on site in a space left in the wall frame. The panels replace the normal studs in the area of wall where they are located and fit between the wall frame top and bottom plates. Dwangs or packing is used to connect between the panels and other studs.
Architects, Architectural Designers, and specifiers should use the Canbrace® X Panel Designers Guide to assist them during the design of a building.
Designers GuideTo assist Designers with calculating the bracing unit values in a structure using Canbrace® X Panel, Specifying Software will soon be available here. A manual calculation sheet is also available here.
Information is also available from www.eboss.co.nz
Should advice be needed about the Canbrace® X Panel product, its
performance, manufacture, or installation, technical support is
available by telephoning (04) 904-4182, by facsimile on (04) 902-5932,
or by email